B3 removal

[FlowmasterFestiva]

93l 5 speed.

im pullin just the engine not the trans and i want to know how to(if needed) unbolt the flywheel from the trancs because i cant find a spot to do it.

[trigerhappy235]

Flywheel and clutch are bolted to the engine, not the trans.

[freshtiva]

Ive always pulled the engine and transaxle as one unit, I know other will disagree though.

[FlowmasterFestiva]

thnaks the engines out now

whats the easiest way to pull the wiring harness and and ecu.

[Tim]

Take off the driver's side fender and thread the harness back through the hole in the firwall into the car (assuming you've taken out the dash already).

I used a pair of wire cutters to speed things up since I wasn't reusing the harness.

ECU and other stuff inside are held on by either a 10 mm bolt or some plastic clips.