Tweet
I am almost ready to weld the power antenna bypass post on my fender reinforcement bar.
After welding, I will cut the middle bar out, grind and paint.
After welding, I will cut the middle bar out, grind and paint.
-
Last edited by bravekozak; 08-06-2017, 06:02 PM. -
That bend came out nice, are you sure there is enough room in the bottom of the fender to clear the bend?
Comment
-
I had to cut a big chunk out of the tube.
Now I have to stiffen it from the inside.
Lots of surgery on this one.
At least it fits over the motor and bracket now.Last edited by bravekozak; 10-01-2017, 06:57 AM.Comment
-
-
Looks great! Good seeing you on here ,I'm not on near as much as before the site changed.Comment
-
Nice work,Brave. yeah it's good to see there are still a few left on here.'88 Festiva LX 5 speed, A/C, Carb, restored $$$ body paint, badly wrecked @ 200k.
'93 Festiva L, 5 speed, Aqua, bought from the original owner,.Zero rust but very nasty otherwise. Awaits the B6T.
'91 Festiva L, 5 speed, bought to drive while putting the B6T in the '93. now B6ME powered.Comment
-
FACE BOOK NEVER UNLESS YOU WANT TO GET ZUCKED......'88 Festiva LX 5 speed, A/C, Carb, restored $$$ body paint, badly wrecked @ 200k.
'93 Festiva L, 5 speed, Aqua, bought from the original owner,.Zero rust but very nasty otherwise. Awaits the B6T.
'91 Festiva L, 5 speed, bought to drive while putting the B6T in the '93. now B6ME powered.Comment
Comment