since the b3 and b6 are so similar can the b6 exaust manifold be used on the b3 stock motor? I searched and couldnt find anything on this so I figured Id ask. What other parts are interchangable just curious.
Announcement
Collapse
No announcement yet.
b3, b6 interchangable parts?
Collapse
X
-
Tags: None
-
Yeah they bolt up, but the b6 hangs down closer to the ground. You'd have to do a simple section cut on the down pipe. I don't know what happens at the cat, because I always take them out of the system!Last edited by iceracerdude; 04-26-2009, 04:07 PM.
-
yes, rods alone are interchangeable from the B3 and B6.
-"Hairlipstiva" 1991 GL 5spd (swapped from an auto), rolling on Enkei 14x6 +38 with 195/45/14 Toyo's, Jensen MP5720 CD deck, tach install, LED strip in cluster, down position rear wiper, FMS springs, Gabriel shocks on 4 corners, Acura Integra short shifter
-Escort GT 91 donor car with BP, G5M-R tranny to be dropped in the little guy...
-Aspire brake swap COMPLETE!
https://www.wunderground.com/persona...?ID=KOKOWASS38
Comment
-
sweet, I know that I should just swap but Im just checking my options. I will end up swapping but I just want to get a little more familiar w/ the car first. and thanks for the correction ice on my last thread about the cam (not more fuel) better air flow.
- I pick up the funbox on sundayLast edited by bobbyspider; 04-27-2009, 12:01 PM.
Comment
-
I know the throttle body i.d. is bigger and i know that the injectors will fit if you have the denso type ( I had a festy that had bosch type and were a little bigger) but they are more flow which will cause a rich condition at idle/off throttle and all around running bad-Greg
Euro-bprt...WORLDS FASTEST FESTIVA !!! 11.78@115.9
BP, G trans, Megasquirt/ 550cc inj. t3/t3 (tbird) Garrett, REAR TURBO!!!! AND AC!!!!
Redneck Engineer
FOTY - '09
5x Festiva Madness Attendee...FM 3,4,5,6,8
http://www.youtube.com/watch?v=LpCZ7...9Pwqw-oe8s2OYQ
http://www.youtube.com/watch?v=vU_eX...9Pwqw-oe8s2OYQ
Comment
-
Originally posted by bobbyspider View Postwhen you go boost what happens to the mass air flow sensor
Mike, AKA the sasquatch
1990 LX, bp+T/g25mr, 9psi dynoed at 194HP, turbonetics t3/to4e 57trim, haltech E6X standalone, 550cc injectors, turbosmart wastegate, synapse BOV, walbro 255 fuel pump, aeromotive FPR, AEM wideband, 3 inch exhaust, huge FMIC, 9LB flywheel, 6 puck clutch and way more parts that im forgetting i installed lol...
Comment
-
Originally posted by bobbyspider View Postwill this leave the check engine light on?
Mike, AKA the sasquatch
1990 LX, bp+T/g25mr, 9psi dynoed at 194HP, turbonetics t3/to4e 57trim, haltech E6X standalone, 550cc injectors, turbosmart wastegate, synapse BOV, walbro 255 fuel pump, aeromotive FPR, AEM wideband, 3 inch exhaust, huge FMIC, 9LB flywheel, 6 puck clutch and way more parts that im forgetting i installed lol...
Comment
-
Originally posted by bobbyspider View Postwhat mazda motor is in the ford probe gt, the older ones
the newer one is a yamaha injected dohc 2.5l which I have seen swapped in to a mx3 that ran 11's
Originally posted by bobbyspider View Postwill this leave the check engine light on?Last edited by nonamekid; 05-10-2009, 08:53 PM.
Comment
Comment