Miata intake mani

[bhearts]

mah plate. Not bad for a hole saw, and some router trimming. Now time for welding... Tomorrow.



Sent from my SM-G900V using Tapatalk

[bhearts]

Free hand router. Fitting a flush 1/4 inch plate over the circle. Welding from the top. uploadfromtaptalk1445737404353.jpg

Sent from my SM-G900V using Tapatalk

[bhearts]

I think it'd be slick shoot to have an integrated intercooler, those end tanks would be awesome as distributing air, such a good taper. Maximal cfm.

Sent from my SM-G900V using Tapatalk

[bhearts]

I can do custom throttle bodies attachments. In case someone wants a bigger throttle if they are running megasquirt

Sent from my SM-G900V using Tapatalk

[bhearts]

I may buy this intercooler and cut off the left side tank in this picture. Attach the core to the runners with a small plenum. So the throttle body would attach top right when looking at the engine. uploadfromtaptalk1445728383861.jpg

Sent from my SM-G900V using Tapatalk

[bhearts]

It's going to be a one piece. With either an intercooler integrated. Or just an na piece. Center throttle body. Maybe facing straight up for direct entrance into the runners from the throttle opening

Sent from my SM-G900V using Tapatalk

[sketchman]

1.6?

What you planning? A bolt on flange for the top half of the Festiva stock piece?

[bhearts]

My aluminum table saw blade was getting dull so I went to harbor freight and purchased their blade sharpener. Worked well. I cut this miata 1.6l intake in half to turn it into a festiva capable mani. uploadfromtaptalk1445726738183.jpguploadfromtaptalk1445726758184.jpguploadfromtaptalk1445726779417.jpg

Sent from my SM-G900V using Tapatalk