Power...

[bravekozak]

no pop

I don't want the hatch to pop open. just unlock when I double push the Viper remote open button. I sometimes push the wrong button without looking (remote in pocket). I don't want to have to go to the vehicle and push the hatch shut.

[resuwrecked]

^^No, you can wire it to lock it too. You know there is a tab on the latch you can push to lock it, so you dont have to lock it with the key, right?

Its not pointless at all. Lots of new cars have an electronic/cable trunk/hatch release.

[freshtiva]

Cool resuwrecked, great idea ! Wish I had more time to spend on my cars to incorporate all these good ideas. Darn working for a living and other BS !!

[resuwrecked]

I also have the working for a living and other bs issues. I stay up all hours of the night to work on my junk haha. Its not that time consuming actually.

[MTec007]

how do i hook this two button, two wire, switch up to 3 actuators? i know a bit about circuits but need that extra "do it this way" push

[Festiva_tunner]

use a set of relays to control the rear actuator - you may have to use two - dual position relays to achive the desired result - if you have a diagram of your switches I can draw you up a skematic of how to wire your relays

[MTec007]

ok for starters what exactly am i looking for in a relay and who sells them?
also what do you mean by a diagram of my switches? i just have the 1 switch that was used in the donor car i assume as a lock/unlock, it has no lables on the buttons but i didnt see any other switches for lock/unlock. what diagram are you needing?

[Festiva_tunner]

ok for starters what exactly am i looking for in a relay and who sells them?
also what do you mean by a diagram of my switches? i just have the 1 switch that was used in the donor car i assume as a lock/unlock, it has no lables on the buttons but i didnt see any other switches for lock/unlock. what diagram are you needing?

Check you PM's

[MTec007]

on the right you see a resistor, as follows:

Value [Ω] Shorthand Color bands (5% tolerance) Range (5%) [Ω]
1k 1K Brown, black, red, gold 950Ω - 1.05kΩ

http://lh4.ggpht.com/_gGCBcInkbVs/S7KAG8pO0QI/AAAAAAAAAZs/RofC3mp4OOw/s640/0330001739.jpg

[resuwrecked]

get your dvom and check what wires have continuity when you push each button then run wires to your relays, if you want to use relays.

[MTec007]

whats a dvom? what relays should i use? also what are they for?

[resuwrecked]

vids everywhere now

[freshtiva]

Thats the shortest video Ive ever seen. I liked it though !

[bravekozak]

other clamp

Mr. Resuwrecked, please bring the other 1/8" clamp to Ohiostiva. I will buy it off of you.

[resuwrecked]

it will be used by then. you can get them at the hardware store.