M3NTALS B6T Build Thread pics always

[Flyin4stroke]

Not including the car?

[Charlie1717]

Total Investment in the car including paint, parts, buying a capri xr2, machine shop, accessories (hids) 20 cans of brake kleen lol about 3000 total.

pretty much built from ground up with almost everything new..shocks, sway bar, bushings, LCA, bearings, rotors, tie rod ends, head (valve job, resurfaced, seals) block cleaned, honed, crank mic'd polished, radiator, fan, IC, IC piping, rings, thrust washers, rod bearings, main bearings,gaskets, radiator hoses, heater hoses, coolant crossover tube, thermostat, paint for transmission, axle seals. Etc etc you get the idea lol

Honestly that's not to bad for all you have done and all the new parts. Looks like you did some good work!

[M3NTAL]

Including the xr2 not the festy ( 600 I think I paid for the car from Skim)

[SiC sEnSe]

Total Investment in the car including paint, parts, buying a capri xr2, machine shop, accessories (hids) 20 cans of brake kleen lol about 3000 total.

pretty much built from ground up with almost everything new..shocks, sway bar, bushings, LCA, bearings, rotors, tie rod ends, head (valve job, resurfaced, seals) block cleaned, honed, crank mic'd polished, radiator, fan, IC, IC piping, rings, thrust washers, rod bearings, main bearings,gaskets, radiator hoses, heater hoses, coolant crossover tube, thermostat, paint for transmission, axle seals. Etc etc you get the idea lol

Man that's awesome great job car looks killer I hope to start my project up again sooner then later

You wouldn't br interested in some racing seats would ya?!? *wink wink*

[skimsucka]

Capri is now at the junkyard and the motor is mounted in Sunday will be a big day of progress axles tie rods ends and wiring/dash

[chrisofna]

Damg, I would of took those wheels if you didn't want them. Be a good side project.

[skimsucka]

Damg, I would of took those wheels if you didn't want them. Be a good side project.

capri wheels? I know Mark regrets junkin them to now too bad we don't own our own junkyard!!

[M3NTAL]

If I remember correctly the rims were all curb rashed to all hell.

[chrisofna]

Meh, could of used them for another set for slicks or something.

[M3NTAL]

7/14/11 Me and Rj made a new front tranny mount and drilled 2 holes in the cross-member just to the left of the existing holes

[M3NTAL]

Update 7-17-11

Installed Axles, Brake Calipers, New Pads to match new 10.2 Rotors, new tie rod ends, set the toe, installed rear wheel spacers with stud kit, put new wheels on, new copper washers for the banjo bolts, dropped the radiator in the car, but it needs to be modified.









Just surface rust from not being used yet

[stillslow5]

Those wheels look tight

[Damkid]

Does it run yet :lol: jk looking great!!

[skimsucka]

Does it run yet :lol: jk looking great!!

it will tomorrow we have off all day starting at 7 am!

[skimsucka]

b6t with ac has been done. I think it belongs to Musclecar1 (Kemp)

does anyone have a pic of this and/or know if it was with a Gseries trans as well cause that makes a huge difference !

i searched forever never saw any proof