Announcement

Collapse
No announcement yet.

My last engine swap build thread, FANTASTIVA

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Gluing the intake to gather, making it permanent . Stripped back the wire harness to gain some slack in the VAF plug. Bought fluids yesterday, may have to give it a whirl this weekend to see what happens. Still no exhaust yet.
    sigpic
    The Don - Midwest Festiva Inc., Missouri Chapter

    Link to my festiva pictures below
    https://fordfestiva.com/forums/album.php?albumid=10
    Celebrating 25 years of festiva(s) ownership.

    Comment


    • Can someone help me out with transmission fluid amt ? 1993 escort gt five speed hydraulic clutch. I've got a capri speedo gear on and I'm not sure if the dipstick marks are accurate. Also I changed disty cap and rotor. Thinking the rotor would only fit in one position I pulled it off without noticing which way it was pointed. I guess it will go on in three positions. Any danger trying to start until I find the right spot ? Just drained the gas tank to put in new fuel. Only had to drain three gallons, smelled fine. The last couple of times I've had to drained a tank they had at least 1/2 a tank in them.
      Last edited by freshtiva; 05-18-2013, 04:49 PM.
      sigpic
      The Don - Midwest Festiva Inc., Missouri Chapter

      Link to my festiva pictures below
      https://fordfestiva.com/forums/album.php?albumid=10
      Celebrating 25 years of festiva(s) ownership.

      Comment


      • it's hard to get the distributor in upside down (180 out) if you have to force it it's wrong. One side is thicker than the other by not much. Then just make sure the rotor button is pointed at #1 at tdc on #1 cylinder. or crank it and if it doesn't run right try the next position!



        my bp swap is ...well.. I need to get one of those roundtoits.

        needs the iat sensor ran out, ecu plugged in(wires spliced already) wideband bung welded into the exhaust, rear half of the exhaust finished(lacking a muffler, cherrybomb already in the middle pipe is ran over the axle) fluids and somebody not lazy like me to turn the key. I keep buying other cars and getting sidetracked working on them >.<
        Last edited by zoom zoom; 05-18-2013, 04:56 PM.
        2008 Kia Rio- new beater
        1987 F-150- revived and CLEAN!!!
        1987 Suzuki Dual Sport- fun beater bike
        1993 Festiva- Fiona, DD
        1997 Aspire- Peaspire, Refurb'd, sold
        1997 Aspire- Babyspire, DD
        1994 Aspire - Project Kiazord
        1994 Aspire- Crustyspire, RIP



        "If it moves, grease it, if it don't, paint it, and if it ain't broke don't fix it!"

        Comment


        • I didn't pull the whole distributor just the rotor. It will go on three different ways. Yeah I know about the roundtoits. My project is never a priority so the only work I do to it is when I feel like it. I'm hoping the light at the end on the tunnel will draw me to the finish.
          sigpic
          The Don - Midwest Festiva Inc., Missouri Chapter

          Link to my festiva pictures below
          https://fordfestiva.com/forums/album.php?albumid=10
          Celebrating 25 years of festiva(s) ownership.

          Comment


          • "IT IS ALIVE !!!!"..... Dr. Frankenstein
            Last edited by freshtiva; 05-20-2013, 03:28 PM.
            sigpic
            The Don - Midwest Festiva Inc., Missouri Chapter

            Link to my festiva pictures below
            https://fordfestiva.com/forums/album.php?albumid=10
            Celebrating 25 years of festiva(s) ownership.

            Comment


            • Awesome! Congrats on the first start
              Barbie Car - '90 L-plus_2nd Gen SOHC B6+rear turbo @ 8 psi
              Festycul - '9? 5spd_full roll cage, completely gutted, hydro g-series, B6T @ 15psi, rocketchip ecu,Willwood master cylinder, Mit. Galant VR-4 rotors, Hawk racing pads, capri knuckles, 323 LCA's, BrideLow Max seats, 5pt. harness, lexan windows, fuel cell, aluminum radiator, 323 coilovers
              Elvis - '93 L 5spd_B3+T build in progress
              WhiteGirl - '93 GL Immaculate shape, deciding what to build with it?

              Comment


              • Good for you, does it sound tight.
                An idea can turn to dust or magic, depending on the talent that rubs against it.

                Comment


                • Right on!
                  -Rafe-

                  Things I have for sale.
                  Random Festiva Parts
                  Festiva Non-Swoopy Power Drivers Mirror

                  Comment


                  • Thanks guys ! Karl, it sounds good to me, a little HLA ticking since the motor hasn't been started in 14 months, that will go away. I'm a little in shock that it started right up. Made my very own youtube video. http://www.youtube.com/watch?v=nKDp3...m-upload_owner
                    sigpic
                    The Don - Midwest Festiva Inc., Missouri Chapter

                    Link to my festiva pictures below
                    https://fordfestiva.com/forums/album.php?albumid=10
                    Celebrating 25 years of festiva(s) ownership.

                    Comment


                    • GRATS!!!!!

                      That's AWESOME man, it sounds like it's just a little out of time, but you should be able to fix that!
                      Last edited by zoom zoom; 05-20-2013, 05:02 PM.
                      2008 Kia Rio- new beater
                      1987 F-150- revived and CLEAN!!!
                      1987 Suzuki Dual Sport- fun beater bike
                      1993 Festiva- Fiona, DD
                      1997 Aspire- Peaspire, Refurb'd, sold
                      1997 Aspire- Babyspire, DD
                      1994 Aspire - Project Kiazord
                      1994 Aspire- Crustyspire, RIP



                      "If it moves, grease it, if it don't, paint it, and if it ain't broke don't fix it!"

                      Comment


                      • Originally posted by zoom zoom View Post
                        GRATS!!!!!

                        That's AWESOME man, it sounds like it's just a little out of time, but you should be able to fix that!
                        Was kind of thinking that too. And congrats on getting a YouTube channel. It's way better for video uploads than photobucket!
                        -Rafe-

                        Things I have for sale.
                        Random Festiva Parts
                        Festiva Non-Swoopy Power Drivers Mirror

                        Comment


                        • Wow good job man!!!
                          1993 Festiva L "Wendy" BP n' stuff
                          2013 Mazdaspeed 3 "The Kraken" -Stock.

                          Dave Forget

                          Comment


                          • That is one sweet sound! I'm glad you got it running, and it started right up, too!
                            Dan




                            Red 1988 Festiva L - CUJO

                            Black 1992 Festiva GL Sport - BLACK MAGIC

                            I'm just...a little slow... sometimes:withstupid:

                            R.I.P.
                            Blue 1972 Chevelle SS-468 C.I.D. B'nM TH400-4:56 posi-Black racing stripes-Black vinyl top-Black int.
                            Black on black 1976 Camaro LT-350 4 bolt main .060 over
                            Silver 1988 Festiva L

                            My Music!
                            http://www.reverbnation.com/main/sea...t_songs/266647

                            Comment


                            • Originally posted by freshtiva View Post
                              Thanks guys ! Karl, it sounds good to me, a little HLA ticking since the motor hasn't been started in 14 months, that will go away. I'm a little in shock that it started right up. Made my very own youtube video. http://www.youtube.com/watch?v=nKDp3...m-upload_owner
                              That engine sounds fine, this car is just another example of your workmanship, looks great all the way around.
                              An idea can turn to dust or magic, depending on the talent that rubs against it.

                              Comment


                              • nice job marcus! sounds great
                                Never Hire a Boy to do a Man's Job!!

                                Comment

                                Working...
                                X