Originally posted by bravekozak
View Post
Announcement
Collapse
No announcement yet.
Rear wiper install fail.
Collapse
X
-
i am just an idiot, i drilled the hole an inch to the left of where it should be. That is why the hole is about an inch off I started my measurement on the 2" mark and went to 9.75 instead of 10.75
After looking at my pictures i realized what i did Tomorrow i will drill new holes 1 inch to the right of where they are and it should match up perfectly
Thanks for all your help thoughLast edited by Chobobulous; 01-15-2012, 07:49 PM.
Comment
-
Here is a pic of my rear wiper motor installed.
The hole is 8-3/4" from the left as measured from 0" as in freshtiva's picture.
Personally, I would just go to the junkyard and get a new rear hatch. I got lucky. I found a rust free hatch with the rear wiper and spoiler on it at the junk yard. It only cost me $50 all together.
Otherwise the holes are going to overlap.
I am sure glad we got this sorted out.Last edited by bravekozak; 01-15-2012, 08:11 PM.
Comment
-
The only festiva i have found around here got scrapped 2 days ago. The junkyard in town says there is an 88 on their lot but after 3 days of searching i gave up....
So the result I used the hole saw again to drill out a place for the motor to go.
My metal fabrication skills are pretty sorry...... But the result
Ill pick up bolts tomorrow, its covered anyways right
Comment
-
That's funny. My hatch was originally red before I painted it green! Keep looking. Will it wipe properly one inch off? I guess it should.Last edited by bravekozak; 01-15-2012, 08:30 PM.
Comment
Comment