I am in the process of changing my front wheel bearings and I cannot figure out how to remove the rotor and hub from the steering knuckle. There are 4 bolts that holds the rotor and hub onto the steering knuckle but you cannot fit a socket on the head because half of the bolt head is hidden under the steering knuckle.
I work in a fabrication and machine shop and the head machinest told me that he could possibly fabricate a new spacer that goes in between the bearings or machine down the original in case it has to be done.
I was trying to get a head start on dissassembling this component so my machinest can press the old bearings out and press the new ones in.
Any help would be greatly appreciated.
I work in a fabrication and machine shop and the head machinest told me that he could possibly fabricate a new spacer that goes in between the bearings or machine down the original in case it has to be done.
I was trying to get a head start on dissassembling this component so my machinest can press the old bearings out and press the new ones in.
Any help would be greatly appreciated.
Comment