Tweet
I think I will just add a soft plastic piece on my key chain and use that pry the gas door open. Its a lot less work than rigging something up
-
1993 Festiva L, aspire swapped, selling parts for a BP+T build. -
True...but you have been so creative so far I ams ure you could rig it up!Comment
-
It is going to look similar to this, I hope.
With these wheels
My open style grille with black mesh & maybe a spoiler
1993 Festiva L, aspire swapped, selling parts for a BP+T build.Comment
-
Don't you lose front legroom with those oversize wheels?Comment
-
they are 15x6.5 with a +35 offset. I am going to run 195/45/15 so I doubt I will have any troubles.
1993 Festiva L, aspire swapped, selling parts for a BP+T build.Comment
-
Just put a small magnet on your keychain.That should do it.Get rid of the latch inside.Put a single hinge from another car on the inside that ,when opened ,stays open and when closed ,holds itself closed with a little tension.Originally posted by big_ty2003 View PostLast edited by TONYCASH; 09-23-2009, 10:35 PM.Comment
-
My hinge is actually pretty stiff and holds itself shut pretty well.
Maybe I can get or make a little felt covered magnet pull like you said for my keychain.
1993 Festiva L, aspire swapped, selling parts for a BP+T build.Comment
-
Cut some new gaskets for my smoothie tail lights I am going to install after I finish the paint job. I used some foam rubber I got from work.
I have enough material to make about 4 more sets of these if anyone is interested.
1993 Festiva L, aspire swapped, selling parts for a BP+T build.Comment
-
Those gaskets look good
Comment
-
How's the silver bullet coming along? Haven't seen any updates on the paint work in a while?Comment
-
I started putting it back together last night. My corner lights & my turns in the front won't work.
1993 Festiva L, aspire swapped, selling parts for a BP+T build.Comment
-
not quite put all the way back together yet but here is a pic
1993 Festiva L, aspire swapped, selling parts for a BP+T build.Comment
-
Sweet!-93' L BP swap/e-series, coilovers, RIO front swap, redrilled festy drums, Miata 14" 7 spokes.
-88' Mazda 323 SE, work in progress..
-85' Nissan Sentra 5 spd.Comment
-
My Cressida gas cap door latch release quit working on a day when I was impatient. I put a magnet where it could grab the door. It works pretty good.
qrogerComment
-
Car looks good. As for the gas door why not install a cable out of a 323 that has the lever to open the door? It would also unlock the hatch. They fit in a Festiva.Comment
Comment