Originally posted by drumnerd33
View Post
Announcement
Collapse
No announcement yet.
My n/a super b3 build
Collapse
X
-
Last edited by Chobobulous; 02-10-2013, 04:03 PM.
-
Re: My n/a super b3 build
Also I'm going to wire in a relay on the oil pressure switch for the fuel pump so it only runs when there is oil pressure.
Sent from my LG-LS970 using Tapatalk 2
Leave a comment:
-
Re: My n/a super b3 build
Yup already had it installed before I started this build. I have a wide band afr, oil pressure, vacuum, and volt meter, all the gauges my stock gauges don't have. Plus I put a t in the oil pressure port so I can run a pressure gauge and keep the light in the dash so if I'm not watching the pressure gauge the light in the dash comes on at extreme low pressure.
Sent from my LG-LS970 using Tapatalk 2
Leave a comment:
-
Have you installed an oil pressure gauge? Considering the amount of money you have tied up in the engine, And the fact that it is all new, I think it would be a good idea to have a gauge to monitor at start up. There's a 99% chance everything will be just fine, but even a $20 gauge will work, all you need is a British pipe adapter.Last edited by blkfordsedan; 02-10-2013, 11:38 AM.
Leave a comment:
-
Re: My n/a super b3 build
Yes sir stage 2 clutch... Just in case I do decide to add boost.
Sent from my LG-LS970 using Tapatalk 2
Leave a comment:
-
yowza!!!! your spending some serious money on a b3, spec clutch too!
Leave a comment:
-
Boy you sure made that engine look 'purdy'! Hope she purrs to top it off.
Leave a comment:
-
Originally posted by drumnerd33 View PostWell gonna be dropping in the motor tomorrow.
Sent from my LG-LS970 using Tapatalk 2
Leave a comment:
-
Re: My n/a super b3 build
Well gonna be dropping in the motor tomorrow.
Sent from my LG-LS970 using Tapatalk 2
Leave a comment:
Leave a comment: