Announcement
Collapse
No announcement yet.
What have you done to your Festiva today!?
Collapse
This is a sticky topic.
X
X
-
What kind of rims are they. They look really good. I love the white rims.
Leave a comment:
-
Got my rims from Gauge_Half_Inch_ .. Put on some trim rings and installed.
They look great!
Leave a comment:
-
not yet, I'll drive it around tomorrow evening for a good 20 miles and change the oil to clean it out. it has some hesitation, (I assume lack of compression, which I knew it would have) but runs quiet like it should.
Leave a comment:
-
switched out the b3 ecu with a b6 ecu and finished up a few small things from my swap.
Leave a comment:
-
Reshaped my skidplate and dirtied up mine last night doing some rallying in my friends field. Thankfully I had the foresight to remove my air dam beforehand this time.
To summarize, I have a $26,XXX rattle box that needs some minor welding, may some day blow it's engine, flakes paint off when anything denser than a marshmellow comes into contact with it and has a transmission made of glass.
Leave a comment:
-
Installed 2 new 185 60 R14 on my miata daisy's for the front and have a new alignment! Bad news is my rear axle beam on the left is slightly bent, thats according to the alignment shop. Other than that its fine. Now to check why my rpm drops whenever i push on the clutch.
Leave a comment:
-
Installed flashed ecu in schreurs1's xr2 and boosted it to 16 psi. Very happy with the results
Leave a comment:
-
Originally posted by htchbck View PostMeeting up with Sparky and Yelo today. A set of 185/60R14s and Chuck will be on their way to new homes this afternoon!
Leave a comment:
-
Meeting up with Sparky and Yelo today. A set of 185/60R14s and Chuck will be on their way to new homes this afternoon!
Leave a comment:
-
Fully wired in and mounted my 6.5" Hella driving lights, should the decide to work? OF COURSE NOT!!!, just a little PO'ed right now. Won't be able to work on it until next thursday, and I'll have to borrow my friend's multimeter.
Leave a comment:
Leave a comment: