What have you done to your Festiva today!?

[TorqueEffect]

Yep, I have no idea what is wrong, something to do with the circuit board is being funky.

I have traced the fault to the ground, but I can't find a break anywhere in the trace on the board, even where I might suspect a problem (namely areas where the screw driver slipped and scrapped some of the coating off the trace, I soldered in some wires to jump over those, and still nothing. The bulbs still look good, so they are not the issue.

I am completely stumped. Anyone have a circuit board out of a dead orange tach cluster they would like to donate?

EDIT: Well I didn't bother to look before, but I just noticed the lights behind the blower controls are not illuminating. I would think a fuse, but I already pulled the meter fuse and it was just fine, interior fuse is fine because the radio still hold the time, and the dome light works.

So either there is faulty wiring, or the dimmer switch just decided to fail. FML, I can never have everything working properly in my car at one time can I?

[TorqueEffect]

!@#$!@#$!@#$!@#$!!!!!!!!!

The back light for the cluster is no longer working unless I tap into a different ground, but then the dimmer is useless.

*smashes head into wall repeatedly*

[greywolf200]

Received a shifter rebuild kit from Brave's Four Green group buy.....

[TorqueEffect]

Looks like about 83 days ((150,000 / 75) / 24)

I took one apart and reset it but didn't get everything put back together right and now the odometer doesn't increase at all.

I'ts not all that hard to take apart but getting all the little wheels set back to the right place without breaking anything is tricky.

Well I will report back with my method as soon as I see it works. I did a quick test drive, and can verify the single digit moves, but didn't drive it enough to roll over to the double digits.
What I did because everything looked so fragile, and I didn't want to try and force off the tumbler bar, so what I did was wedge a small flathead screwdriver between each number and it's key to move the key away from the number as much as possible away without breaking anything, and kinda forced the numbers to rotate, you just rotate it until the desired number is straight on the face of the cluster, and wiggle it back and forth till it pops back completely into the key, just repeat for each digit.

I may tear open my worthless speedo cluster and demonstrate this method on video as if it were a Orange Tach cluster, concept should be exactly the same.

But first things first, I have to see if any digits besides the single digit moves, but I do believe that it works.

[RhodeStiva]

A little piece of heaven today

[1990new]

Looks like about 83 days ((150,000 / 75) / 24)

I took one apart and reset it but didn't get everything put back together right and now the odometer doesn't increase at all.

I'ts not all that hard to take apart but getting all the little wheels set back to the right place without breaking anything is tricky.

[TorqueEffect]

Nope, not doing the drill, drill only makes the speedo go up to 75MPH, and to get to 309k miles, I would literally would have to have the drill running at max speed for MONTHS straight.

The drill wouldn't survive it, and not worth the electricity.

[Cquick33]

After seeing a few posts, and hearing my friends who mod miatas rave about plastidip. I tried some on my grille/ hood. It is pretty I retesting stuff given its not permanent unless you want it to be. Did a little test run, and I've learned. If you plan on using the stuff, it doesn't work just like rattle cans. You gotta layer it on thick to where it seems like its gonna run, but it'll dry flat since its actually a sprayable latex. Layer it on thick! But here is a pic for y'all to see how it came out.
image.jpg

[frankenfester]

Now I found out the orange tach cluster are built different from the white ones, instead of using meltable plastic, they used friggin' metal to hold the odometer tumbler in.

Looks like I may just have too hook a drill up to it to get it to over 300k miles. Who knows how long That will take from only 150k.

Tape the drill in place and the trigger and let it run. Lol.

James says, "Hate on it."

[TorqueEffect]

Now I found out the orange tach cluster are built different from the white ones, instead of using meltable plastic, they used friggin' metal to hold the odometer tumbler in.

Looks like I may just have too hook a drill up to it to get it to over 300k miles. Who knows how long That will take from only 150k.

[frankenfester]

Started pulling the tach cluster out so I can change the mileage on it, and the damn cable (Not the cover) is jammed into the speedo gear, I don't want to pull it too hard, because I don't want to have to order another cable, but it used to just slide out. How is that even possible when it is keyed?

Maybe it spun inside the groove and became stuck?

James says, "Hate on it."

[TorqueEffect]

Started pulling the tach cluster out so I can change the mileage on it, and the damn cable (Not the cover) is jammed into the speedo gear, I don't want to pull it too hard, because I don't want to have to order another cable, but it used to just slide out. How is that even possible when it is keyed?

[M3NTAL]

Finally got my Festiva on megasquirt! Woohoo!!

[greywolf200]

Got my MSD and coil from Festevil3 for my hot rod B6.

[frankenfester]

Gotcha!

Sorry about the clarity the first time.

Sent from James' Galaxy S4 TAPATALK2