What have you done to your Festiva today!?

[greywolf200]

Blew it up on the way back from Durham..........:cry_smile: Guess that B6 is gonna be sooner than later.

[TorqueEffect]

Got the engine sealed up, started on rear wheel bearings/drums. Made a bench press:

[ATTACH=CONFIG]12278[/ATTACH]

Hope you know that you don't press in the races, you just tap them in with the old ones, and a block of wood.

Only the front bearings require a press.

[bp71monte]

Got the engine sealed up, started on rear wheel bearings/drums. Made a bench press:

IMG_0514[1].jpg

[Movin]

Wired in a trailer adapter module
A police guy sort of suggested I replace it.
Its amazing the way they can influence
your to do list!

[kellen302]

Got some new wheels at PnP. 13inch steelies off of an old Mustang II. I'll have to get these nasty old tires off (had to slash them anyway so they wouldn't try to charge me for them, don't think 195/70-13 Mud n' Snows will fit real well.) And I got my 165/70-13's waiting here to get put on. Any suggestions on the color for the wheels? I was thinking white or silver spray paint after a clean up with a wire wheel.

[muleskinner]

Got my Festiva back from the Transmission place yesterday. New axles, clutch, throw out bearing. Yay!

NEXT: Replace the rear wheel bearings.

[200KGPGTP]

Swapped ECMs. Car is ready for B6

[crazyrog17]

Weld broke under the exhaust manifold, at the flange. Having it repaired now.

[200KGPGTP]

Just a little wiggle, and a little waggle and it went?

Well I had done an uncomfortable amount of that already. Ended up loosening the pressure plate so the clutch could move just a bit, stuck it in all the way, removed, tightened, put the trans back on, bolted it up.

Also greased all the moving parts in there. Well, except the clutch obviously

[Dwane]

sounds like Festevil3 and I had the same day IMG_1532.jpgIMG_1533.jpgIMG_1534.jpg
tomorrow is air conditioner and heater and pull harness to go into my silver festy

[greywolf200]

Had the front end aligned and discovered that I need LCA's(bushings) and swaybar bushings and the front frame horn pulled.

OH WELL.........:cry_smile:

[drddan]

Just a little wiggle, and a little waggle and it went?

[200KGPGTP]

Got it!!

[200KGPGTP]

What's the issue?

I just can't get it all the way on, I don't know what the deal is

[drddan]

Parked it.

Rear wheel bearings goin' bad. :thumbs_down: