Announcement

Collapse
No announcement yet.

What have you done to your Festiva today!?

Collapse
This is a sticky topic.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • zoe60
    replied
    Damn, Brave. You've really got that thing looking good!

    Leave a comment:


  • bravekozak
    replied
    Fitted underhood padding from another small vehicle.
    Everything references off the centerline with the windshield washer tubing hole serving as true position.

    Took a pic with a polarizing filter.
    Last edited by bravekozak; 08-02-2015, 07:11 AM.

    Leave a comment:


  • Meepersly
    replied
    Adjusted Fuel-Air ratio and Changed ignition timing. Going to fine tune both tomorrow when I have a timing light available.

    1988 Festiva LX

    Leave a comment:


  • bravekozak
    replied
    I installed sound deadener today. I did not want to cut the large, heavy sheets. So, I unfolded them, removed the door windows, slid the deadener through the belt moldings, then in behind the door reinforcement braces and then re-installed the glass. No problemo. I need to buy some deadener for the roof and rear fenderwells. Deadener really does make a big difference!
    Can someone please tell me what the distances are between the ceiling braces?
    Last edited by bravekozak; 07-25-2015, 06:13 PM.

    Leave a comment:


  • AMY0826
    replied
    Took the cheesy universal seat covers off that came with the purchase & folded them into the driver seat for lux duck (brand) tape lumbar padding ... the seat vinyl on either side of the fabric middle bit in the seats was failing , but dont i HATE seat covers . Esp $19 black & gray ones ... more comfy now !

    Leave a comment:


  • ottoparts
    replied
    Picked these up from the wrecking yard today.

    20150718_110106.jpg

    Leave a comment:


  • ottoparts
    replied
    I went and put on my Rx7 steering wheel!

    20150711_155056_resized.jpg

    Leave a comment:


  • crazyrog17
    replied
    Originally posted by Advancedynamix View Post
    Not to pick on you, but this is a good place to post a tip:
    Gas struts should be mounted with the piston seal down to keep it lubricated and debris out

    Leave a comment:


  • TorqueEffect
    replied
    Dangit, there is a nice minimal rust 88' Festiva in my town for $400, I bet the buy will take $300 for it since it has a cracked head. But I don't have the money!

    Leave a comment:


  • sketchman
    replied
    Yanked the rear bumper cover. Things planned for it.

    Also took it to the top speed limit. Wish I'd had my GPS in the car at the time. In 4th and WOT speedo pegged for a good long while till it just sort of hit a wall and wouldn't do any more. I'm definitely gonna get killed when it's finally boosted.

    Leave a comment:


  • TorqueEffect
    replied
    Gave it an oil change, and re-advanced the timing.

    Didn't realize Valvoline racing synthetic was green. lol

    I only got the stuff because it was being clearanced a while back for $1/quart.

    Leave a comment:


  • sketchman
    replied
    New control arms and urethane bushings for all 4 sway bar mounting points.

    LOVE them. Love Florida cars too. I pulled both control arms out of the knuckles by hand. They almost fell out. drool

    Leave a comment:


  • sactnato
    replied
    Drove my Festiva from Virginia to Florida ahead of my permanent move next week....800 miles @70MPH and got 41MPG!

    Leave a comment:


  • navdoc101
    replied
    Quiet, not quite.
    Heaven.

    Leave a comment:


  • bravekozak
    replied
    Advanced, think penguin.
    The days will start getting shorter again beginning tomorrow.
    Last edited by bravekozak; 06-20-2015, 09:59 PM.

    Leave a comment:

Working...
X