What have you done to your Festiva today!?

[Christ]

Just rolled over 100k on Steve this weekend.

[milehighbear]

Well, was putting air in tires and grabbed each tire and shook it and all were tight except for rear passenger tire, had a little wiggle in it. So jacked it up, took cap off and pulled pin and nut was a little loose. I tightened it down about 3/4 turn and wheel tightened right up. Guess I'll have to go drive it now and see if any sounds come from it. I think I'll also plan day to take rear wheels off and grease them.

[junspeed]

I giggled like a kid in a candy store the whole way home! It's the car that has a makeshift turbo kit from a mitsu. Blown head gasket i suppose... No matter, gonna get the brakes and suspension off it.

Turbo kit is cool man. Now I know why it's smokin like that lol. So you'll get some parts off it. I assume it's an aspire?

[Skrapbob]

Hey how are you man? Looks like a wild chase lol

I giggled like a kid in a candy store the whole way home! It's the car that has a makeshift turbo kit from a mitsu. Blown head gasket i suppose... No matter, gonna get the brakes and suspension off it.

[junspeed]

My swap followed me home. She was smoking! My camera was on B&W setting
[IMG] Uploaded with ImageShack.us[/IMG]

Hey how are you man? Looks like a wild chase lol

Changed my master brake cylinder (for the first time), didn't have to bleed the entire system, bled the master from F to R fittings (1 at a time), air went out after like 4-5 sets of 20 pumps with the help of my youngest son. I remember rebuilding a rear left wheel cylinder then bleeding just on that same side. Makes sense, air would come out where it entered (nearest point) with strong pressure of course. I saved a lot of time, labor, and brake fluid

[gauge_half_inch]

Finally did a compression test on my current b6... Not good. 160,150,150,75. Added a little trans fluid to #4 it jumped up to 185... Rings are done... Really need to get my other bottom end all assembled.

[Skrapbob]

My swap followed me home. She was smoking! My camera was on B&W setting
[IMG] Uploaded with ImageShack.us[/IMG]

[200KGPGTP]

Changed oil.

[Christ]

:shock:You want faster? :shock:

You don't? :shock:

[Movin]

Installed a split folding rear seat, got it inspected. Got the sticker, but I need to rebuild or replace the steering rack.

Any close ratio racks that fit?

:shock:You want faster? :shock:

[Christ]

Installed a split folding rear seat, got it inspected. Got the sticker, but I need to rebuild or replace the steering rack.

Any close ratio racks that fit?

[Movin]

After watching how it looked for a week or so I raised the back
another inch and 1/4 ...It looks really good!!

[bravekozak]

Today, I decided to install the one way vacuum check valve for the power brakes. I took two hoses from some different junk yard vehicles and installed the valve in midair. I didn't like the way it looked and decided to install an acura bracket to the firewall. The valve looks a lot better mounted in the bracket. The problem was that the KB laser intake manifold has the vacuum fitting mounted sideways on the first intake runner, down low.

[Christ]

@movin - It doesn't look terrible or anything, but IMO it looked better from afar. LOL Ingenuity doesn't have to be pretty, and my opinion doesn't really count, though.

[navdoc101]

Painted front bumper cover black. Clear coated it. Installed new horn.